Make the most of your GoBe U experience by following these best practice tips. These recommendations help improve the accuracy of measurements and prolong the lifespan of your device.
Switching On the Band
Before putting on your GoBe U:
Press the control button once.
The diode pad will light up to indicate the battery level:
Green - high battery
Yellow - medium battery
Red - low battery
Wearing the Band
Wear your GoBe U on your wrist continuously for 22–23 hours a day, including during sleep.
Continuous wear allows the device to accurately measure calorie intake and other key metrics.
Synchronization
After initial setup, synchronization with the HEALBE app happens automatically, as long as:
Bluetooth is enabled
The HEALBE app is running on your phone
Updating Weight
Weigh yourself 2–3 times a week and update your weight in the app.
This helps GoBe U fine-tune its internal algorithms for better tracking and goal-setting.
Battery Сare and Storage Recommendations
GoBe U automatically switches off when the battery is critically low.
To turn it back on, simply connect it to the charger.
To maintain battery health, avoid storing the device in a fully discharged state, as this may lead to capacity loss over time. If you are not planning to use the band for an extended period, we recommend charging it beforehand.
For long-term storage, you can use the storage mode (available only on basic firmware):
Make sure the band is not connected to a charger.
Perform a Factory Reset:
Turn off the band by holding the button for 3 seconds (purple light will appear).
Make sure it is off (no light when pressing the button).
Press and hold the button for 7 seconds, then release it.
The reset will be indicated by red, yellow, and green blinking lights.
(Note: this will erase current data, so it’s best to sync the device beforehand and perform the reset in the morning.)
After the reset, press and hold the button again for more than 7 seconds until you see two orange flashes — this means the device has entered storage mode.
To exit storage mode, simply place the band on the charger.
Hygiene
To avoid skin irritation, regularly wash your wrist, sensors, and strap with soap and water.
Keeping the device and skin clean supports long-term comfort and performance.
Sensor Adjustment
After putting on the band, give the sensors a few minutes to adjust to your skin.
If contact is not detected within the first minute, you will see a message in the HEALBE app.
If you have any additional questions or need support, feel free to reach out - we’re here to help!