Skip to main content

GoBe3: Getting started with the device

GoBe3, getting started, setup, set up GoBe3, activate GoBe3, activation, first use, connect GoBe3

Written by Maria

Follow these steps to set up your GoBe3 and start using it.

1. Prepare Your GoBe3

Before using GoBe3 for the first time:

  • Remove the protective film from the sensors on the back of the band.

  • Wipe the external surfaces with a clean, dry cotton pad.

GoBe3 may arrive with a low or empty battery, so charge it before completing the setup.

2. Charge and Turn On GoBe3

To charge your GoBe3:

  1. Open the charging port cover on the back of the band.

  2. Insert the charging cable into the charging port. Make sure the HEALBE logo on the cable is facing the sensors.

  3. Connect the other end of the cable to a computer USB port or a compatible power adapter.

  4. Wait for GoBe3 to turn on and display the welcome screen indicating that it is ready to connect to the HEALBE app.

GoBe3 turns on automatically while charging once the battery reaches a sufficient level.

3. Connect GoBe3 to the HEALBE App

Make sure Bluetooth is enabled on your smartphone.

Then:

  1. Open the HEALBE app.

  2. Keep your phone within approximately 90 cm (3 ft) of GoBe3.

  3. Follow the instructions in the app to connect and activate the band.

  4. Wait for the automatic setup to finish. The GoBe3 firmware may be updated during this process.

Keep GoBe3 connected to the power source until the battery is fully charged. A full charge normally takes up to 2 hours.

Once charging is complete, disconnect the cable from GoBe3 and securely close the charging port cover.

4. Put On Your GoBe3

Wear GoBe3 on your wrist and adjust the strap so that the sensors maintain consistent contact with your skin without feeling uncomfortably tight.

After you put the band on, the sensors may need approximately 10 seconds to 2 minutes to establish proper contact with your skin.

If GoBe3 cannot establish sufficient contact, a corresponding message will appear on the band’s display.

5. Wear GoBe3 Throughout the Day

For the most complete data, we recommend wearing GoBe3 throughout the day and night - approximately 22-23 hours per day.

The band displays your main metrics, while more detailed information and trends are available in the HEALBE app.

When GoBe3 is turned on and ready to use, the current time is displayed on the screen.

6. Sync Your Data

To sync your data with the HEALBE app:

  • Open the app and keep GoBe3 within approximately 90 cm (3 ft) of your phone.

  • GoBe3 will connect to the app and synchronize the available data automatically.

Your phone does not need to remain continuously connected to GoBe3 throughout the day.

7. Keep Your Weight Up to Date

We recommend weighing yourself regularly and updating your weight in the HEALBE app at least 2-3 times per week. Keeping your weight information current helps improve the accuracy of HEALBE algorithms.

Important

Avoid direct contact between GoBe3 and insect repellents, as they may damage the surfaces of the band.

You can also watch our GoBe3 Getting Started video for step-by-step instructions.

If you have any questions, please contact HEALBE Customer Care at gobe@healbe.com.

Did this answer your question?